Framing Pocket Door Rough Opening

Once you have determined that the header is level secure each side with screws.

Framing pocket door rough opening.

Just add 2 to the width of the actual door size. Rough opening height from sub floor for 6 8 door. Before you start framing a wall to accept a pocket door you ll need to choose a pocket door frame. Now all you need to know is how to properly frame your door rough opening.

You may have to trim your header. The wider part of the header goes over where the actual door opening will be. It s a very specific height and width both called out in the written pocket door installation instructions. This will give you room to space the door frame off of the sub floor.

Be careful to keep the cut shallow. Take out the section of drywall which is above the door in order to frame the new header. 84 84 84 84 84 rough opening height from sub floor for 7 0 door. This will need to be 1 inch 2 54 cm more than twice the length of the pre existing header since it will need to span the distance of the entire rough opening.

Note that any load bearing wall will need the ceiling above it to be adequately supported during remodeling and a new load bearing 2x header must be constructed above the rough opening. This is the last of the interior framing. Then the pocket door frame header will rest on these nails while you make sure everything is level. If your door is under 200 lbs the maximum door height will be the ro height 3 5 assuming finished floor thickness or 2 75 if measured from finish.

Use a section of 2 by 4 5 08 by 10 16cm as the new header. While shooting this video. Finish door size2 0 2 4 2 6 2 8 3 0. Framing rough opening sizes are really quite simple.

While this opening looks very large it must accommodate the door once it slides in the pocket to open. Dimensions of rough openings for pocket door frames. The rough opening is the foundation of your system. The rough opening for the pocket door is the rectangle created by the wall studs.

Make the rough opening for a pocket door two times the width of the door plus 1 inch with a height of 84 1 2 inches from the highest spot on the subflooring. Determine the door height from a rough opening existing pocket framing step 1. The rough opening for one of their pocket door frames is two times the door width plus an inch 2 door width 1 inch for the width and 5 inches plus the door height for the header height. In this video we frame out the bathroom including the rough in space for a pocket door.

We like the pocket door frames that johnson hardware sells. What is the pocket door rough opening. Using 2 4 studs frame a new rough opening to fit the dimensions for the door jamb indicated by the manufacturer of the pocket door kit.