Flushing Water Lines In Rv

Our current rv has no gravity fill so the only way to get water into the fresh tank is through the hose that connects the rv to city water.

Flushing water lines in rv.

Let your rv sit overnight with the water lines filled with the bleach water solution in the lines. Then attach the hose to the fresh water faucet and turn it on. Flush fresh water tank with clean water. Open the hot water heater tank drain valve and leave it open until all the water has drained out.

Connect the other end to your rv clean water intake connection. Stale stagnant water left in the rv s water lines can encourage harmful bacteria growth. Pex stands for cross linked polyethylene. If you need to repair a larger section simply buy a water line that is the same length as that you intend to cut and the appropriate rv water line fittings.

Your rv will be safe in the cold until you re ready to get behind the wheel again. This isn t as complicated as it sounds. Why flush rv water lines with floë. Floë solves this concern by pushing compressed air through your rv s fresh water lines.

Flush until the water runs and tastes clean. Once the tank is dry fill it up again but this time you re going to stick to clean. Turn off the water to the rv and make sure your water pump is off. They are not buried inside walls and are usually accessible for easy repair.

That s because the water lines in most rvs are plastic pex pipe. Open your gray tank and turn on all the faucets. Some rvs that have only a city water fill no gravity fill also have winterizing kits that are plumbed like yours with no way to add water to the tank through the kit. The 12 volt water pump should be turned off when you aren t going to be near the rv.

You won t have to spend money pouring buckets of antifreeze down the drain like other rv owners do. An industry first water drainage system that cleans your rv s fresh water lines and tank with the flip of a switch. Turn power off to the hot water heater. Attach the white water hose mine is 25ft to the rv fresh water intake valve.

It is located just outside of the fresh water tank where it pulls the water through itself and into the water main. Simply hook your clean water hose to your garden tap or city water tap if you are at a campground. Open the relief valve on top of the water heater to expel any pressure in the hot water tank. Drain all of the water tanks and flush the lines with compressed air to clear them out.

Pour the diluted bleach into the other end unattached of the white hose make sure the unattached end is higher than the end attached to the rv. After your rv has sat for a good length of time with the bleach water solution in the lines and tank it s time to open the faucets and empty it. The water line in your rv was installed with some slack so if you have a split line you can simply cut out the part with the slit then rejoin the two ends with a water line fitting.